Red BallMAKER MOLD for making SLUGS cal. 68 for HDS 68 RAM T4E better slug maker

Description

The BallMAKER MOLD is for casting cal. 68 SLUGS, mainly for HDS 68 RAM shotgun.
The BallMAKER mold is made of a durable resin, the cast is quite simple and it need the cheapest hot glue gun.
Slugs casted using this mold
have high accuracy
and depending on the type of tip used
high impact power
.
Making such balls of hotglue yourself is very cheap compared to other ammunition on the market!
To increase the weight of the cast slugs, it is best to use steel bearing balls.
The heavier the ball, the harder it hits the target, or more effectively disable the attacker.
Twisted shape causes that the slug does meet with less resistance in the barrel
and accurately hits the target. The hollows at the bottom uses all the fired CO2 gas,
which gives the slug maximum shot speed and increasing it range.
BallMAKER slugs have center of mass on the tip that slugs always hit with it.
Each mold is sending with
casting instruction
and some,
free different steel balls
.
Instructions for casting slugs you can also watch on a movie with similar mold:
WARNING: YOU SHOOT YOUR OWN RELEASED SLUGS AT YOUR OWN RISK !!!
WARNING: REMEMBER THAT THE GUN DAMAGE CAUSED BY SHOOTING FROM THESE SLUGS ARE NOT SUBJECT TO COMPLAINTS !!!
DO NOT SHOOT TO PEOPLE AND ANIMALS!!!