-40%
O2 Sensor Type A-01T - Oxygen Sensor - Oxygen cell Automotive
€ 24.32
- Description
- Size Guide
Description
Sensor Typ A-01TO
2
Sensor Type A-01T
High quality oxygen senors made in Germany
This oxygen sensor ist compatible for all AU-devices with jack connection (shown in photo) as for example Allen, AVL, Bear, BrainBee, SPX, Beissbarth, Cartec, Crypton, Grundig, Hermann, KWT Autosense, Mannesmann Kienzle, Motorscan, Maha, Pittracher, Protec, Protech, Prüfrex, Sagem Sourio, Saxon Junkalor, Tecnomotor, Texa, VLT, Lucas, SUN (neueren Modelle DGA), Würth WOW, Electra-Control - MAG 4000 T, GATS, MRU – Delta 1600 L, Pittracher – Infrarot-CO/HC-Gasmotoren Tester, Protec, Protech, Prüfrex (all), Sagem Souriau, (all), Snap-on, Szenzortechnika, Tecnotest (all).
• PTB-A 18.10 tested
• Fits BAR 97 requirements
• Produced according to DIN EN ISO 9001
• Fast and reliable resonance
• Resistant to CO
2
contamination (<14% CO
2
/64h)
• Excellent signal stability
• High product quality
• Tested and Approved by the PTB for the official AU as in § 47a
Exhaust Gas Sensor Modern management systems to ensure compliance with the fuel-air ratio within very narrow limits safely. The aim is to minimize fuel consumption and pollutant emissions of the engine. The correct function of the system can be checked by measuring the exhaust gas composition and the calculation of the fuel-air ratio. The exhaust gas components carbon monoxide (CO), carbon dioxide (CO
2
), hydrocarbon (HC), nitrogen oxides (NOx) and oxygen (O
2
) must be measured with high accuracy for this purpose. In particular, the measurement of oxygen are high demands.
The oxygen sensor Model A-01T has the following properties :
All characteristics are based on conditions at 25°C, 50% RH and 1013 hPa
Electrical connector:
3-pin Molex
Measurement Range:
0 - 100 Vol. %
Output signal:
9-13,5 mV @ dry ambient air
Response time t90:
< 5 s
Accuracy:
• 2 % oxygen: ± 0,1 % absolute
• 25 % oxygen: ±0,5 % relative
• 100 % oxygen: ± 1,0 % relative
• (calibrated @ dry ambient air)
Interferences:
< 0,1 % O
2
response to:
- 15,0 % C0
2
balance N
2
- 10,0 % CO balance N
2
- 3000 ppm NO balance N
2
- 3000 ppm C3H8 balance N
2
- 500 ppm SO
2
balance N
2
- 1000 ppm Benzen balance N
2
Signal response to N
2
< [Ua/200] in 100 % N
2
less than 40s
Recommended Load Resistor:
> 10 kOhm
Operating Temperature:
0-50 °C
Recommended temperature range:
5 - 25 °C
Maximal temperature range:
-15-60 °C
Weight:
appr. 25 g
Influence of Humidity:
-0,03% rel. 0
2
reading per RH
Materil in contact with Media:
• Polyamid 12, PPS
• Stainless steel 1,4571 (AISI 316 Ti)
• PTFE (Teflon®)
Here you can download more information
Sensor AU device references