BallMAKER Silicon MOLD making Cylinder SLUGS cal. 68 for HDS or FSC First Strike

Description

The BallMAKER Silicon MOLD is for casting cal. 68 SLUGS, mainly for
HDS
68 RAM
shotgun
or
FSC
First Strike guns.
The BallMAKER mold is made of a silicon, the cast is quitesimple and it need the cheapest hot glue gun or other low temperature casting material. Slugs casted using this mold have high accuracy and depending on thetype of tip used high impact power.
Making such slugs of hotglue yourself is very cheap compared to otherammunition on the market! To increase the weight of the cast slugs, it is best to use steel bearingballs. The heavier the ball, the harder it hits the target, or more effectivelydisable the attacker. Mushroom shape causes that the slug does meet with less resistance in the barrel and accurately hits the target. The hollows at the bottom uses all the fired CO2 gas, which gives the slug maximum shot speed and increasing it range.
BallMAKER slugs have center of mass on the tip that slugs always hit with it.
Each mold is sending with castinginstruction and some free different steel balls.
WARNING: YOU SHOOT YOUR OWN RELEASED SLUGS AT YOUR OWN RISK !!! WARNING: REMEMBER THAT THE GUN DAMAGE CAUSED BY SHOOTING FROM THESE SLUGS ARE NOT SUBJECT TO COMPLAINTS !!! DO NOT SHOOT TO PEOPLE AND ANIMALS!!!